Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY › from 2015.08
RM2660E _52 Drivetrain _052811 DRIVE SHAFT / PROPELLER SHAFT _0255343 FRONT DRIVE SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 43420 1.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

a.

Coat the lip of the differential oil seal with MP grease.

HINT:

Inspect the oil seal for wear or damage.



b.

Coat the spline of the inboard joint shaft assembly with hypoid gear oil.


c.
C358768

Align the shaft splines and install the drive shaft with a brass bar and hammer.

NOTICE:
·

Set the snap ring with the opening side facing downward.

·

Be careful not to damage the oil seal.

·

If the outboard joint shaft is new, remove the anti-rust oil on the screw end with non-residue solvent.



HINT:

Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when tapping in the shaft.



Hide 2.INSTALL FRONT AXLE ASSEMBLY LH

Hide 51405A 5.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53806 6.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 7.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH