The suspension control ECU receives signals from the VGRS ECU (steering control ECU) via CAN communication.
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| C1785 | While the engine switch is on (IG), the steering control ECU malfunction signal is received for 5 seconds. | ·
Variable gear ratio steering system (VGRS system) ·
Suspension control ECU |
Before performing troubleshooting, inspect the connectors of related circuits.
If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>INITIALIZATION).
Check if a DTC is output from the variable gear ratio steering system (See page Steering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Clear the DTCs (See page Suspension>SUSPENSION CONTROL>ACTIVE HEIGHT CONTROL SUSPENSION>DTC CHECK / CLEAR).
NEXT
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1785 is output | A |
| DTC C1785 is not output | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)