Home › Suspension › SUSPENSION CONTROL › DAMPING FORCE CONTROL ACTUATOR(for Rear Side)
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0255379 DAMPING FORCE CONTROL ACTUATOR(for Rear Side) A

SUSPENSION CONTROL  DAMPING FORCE CONTROL ACTUATOR(for Rear Side)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1. SUSPENSION FLUID PRESSURE RELEASE

Hide 489B0 3.REMOVE HEIGHT CONTROL UNIT PROTECTOR ASSEMBLY LH

Hide 4.DISCHARGE SUSPENSION FLUID PRESSURE

a.
C172940

Connect a hose to the bleeder plug for the shock absorber control valve and loosen the bleeder plug.


b.

Discharge the suspension fluid pressure.


c.

After the fluid pressure has dropped and oil has drained out, tighten the bleeder plug and remove the hose.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


Hide 49151B 5.REMOVE REAR SUSPENSION CONTROL ACCUMULATOR ASSEMBLY LH

a.
C172802

Remove the control accumulator from the control valve.


b.

Remove the O-ring from the accumulator.


Hide 49158D 6.REMOVE REAR NO. 3 SUSPENSION CONTROL ACCUMULATOR LH

a.
C176191

Remove the No. 3 control accumulator from the control valve.


b.

Remove the O-ring and back-up ring from the control accumulator.


Hide 48040 7.REMOVE REAR SHOCK ABSORBER CONTROL VALVE ASSEMBLY LH

a.
C172804E01
0.141,3.955 2.777,4.111 2.637,0.156 10 No. 4 Suspension Control Pressure Hose 1.741,2.761 1.741,3.897 false 0.668,3.42 1.192,3.582 0.524,0.162 10 Gasket 0.973,2.905 0.973,3.411 false 2.725,0.691 3.254,0.834 0.528,0.143 10 Bracket 2.688,0.766 1.835,0.766 false 0.936,0.133 2.814,0.288 1.878,0.155 10 Shock Absorber Control Valve 1.291,2.011 0.46,0.992 false 0.46,0.992 0.46,0.202 false 0.46,0.202 0.89,0.202 false 1.835,0.766 1.835,1.508 false

Disconnect the control valve connector from the control valve.


b.

Remove the union bolt and gasket from the No. 4 suspension control pressure hose.


c.

Disconnect the wire harness clamp from the control valve bracket.


d.
C172803E01
2.256,0.405 3.134,0.737 0.878,0.332 10 No. 4 Height Control Tube 1.929,1.215 3.113,1.372 1.184,0.157 10 Union Nut Wrench 1.9,1.296 1.746,1.296 false 1.746,1.296 1.746,1.478 false 2.236,0.497 2.012,0.497 false 2.012,0.497 1.615,0.945 false

Using a union nut wrench, disconnect the No. 4 height control tube from the control valve.


e.
C172668

Remove the 3 bolts and control valve with the bracket from the vehicle.


f.
C172669

Remove the 3 bolts and bracket from the control valve.


Hide 491B2 8.REMOVE REAR NO. 2 SUSPENSION CONTROL ACCUMULATOR BRACKET LH

a.

Remove the bolt and bracket from the shock absorber control valve.