Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
48826D
1.REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)
48860D
2.OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
3.REMOVE REAR WHEEL
4.DRAIN BRAKE FLUID
46430
5.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
46420
6.DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
42306
7.DISCONNECT REAR AXLE BREATHER HOSE SUB-ASSEMBLY
8.SUPPORT REAR AXLE HOUSING ASSEMBLY
48825A
9.DISCONNECT REAR STABILIZER END BRACKET (w/ KDSS)
Remove the 2 bolts and disconnect the stabilizer end bracket.
48830
10.DISCONNECT REAR STABILIZER LINK ASSEMBLY (w/ KDSS)
Remove the nut and disconnect the stabilizer link from the stabilizer bar.
Do not lose the ball Joint dust cover protector.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
48825A
11.DISCONNECT REAR STABILIZER END BRACKET LH (w/o KDSS)
Remove the 2 bolts and disconnect the stabilizer end bracket.
48825A
12.DISCONNECT REAR STABILIZER END BRACKET RH (w/o KDSS)
Remove the 2 bolts and disconnect the stabilizer end bracket.
48740
13.DISCONNECT REAR LATERAL CONTROL ROD ASSEMBLY
47318F
14.DISCONNECT REAR FLEXIBLE HOSE
48540
15.DISCONNECT REAR SHOCK ABSORBER ASSEMBLY LH
Remove the bolt on the lower side of the shock absorber.
Disconnect the shock absorber from the axle housing.
48530
16.DISCONNECT REAR SHOCK ABSORBER ASSEMBLY RH
Remove the bolt on the lower side of the shock absorber.
Disconnect the shock absorber from the axle housing.
48231B
17.REMOVE REAR COIL SPRING LH
While lowering the axle housing, remove the coil spring.
Be careful not to snap the brake line.
48302
18.REMOVE HOLLOW SPRING SUB-ASSEMBLY
Remove the hollow spring from the frame.