Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
48826D
1.REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)
48860D
2.OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)
3. SUSPENSION FLUID PRESSURE RELEASE (w/ Active Height Control)
4.REMOVE REAR WHEEL
5.REMOVE EXHAUST PIPE ASSEMBLY (w/ Active Height Control)
for 1GR-FE: Engine / Hybrid System>1GR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL
for 1UR-FE: Engine / Hybrid System>1UR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL
for 1VD-FTV: Engine / Hybrid System>1VD-FTV (INTAKE / EXHAUST)>EXHAUST PIPE(w/o DPF)>REMOVAL
for 3UR-FE: Engine / Hybrid System>3UR-FE (INTAKE / EXHAUST)>EXHAUST PIPE>REMOVAL
58321B
6.REMOVE REAR NO. 1 FLOOR HEAT INSULATOR (w/ Active Height Control)
Remove the 3 bolts and rear No. 1 floor heat insulator.
| *A | for LHD |
| *B | for RHD |
7.REMOVE FUEL TANK (w/ Active Height Control)
When removing the rear shock absorber assembly RH, also remove the fuel tank.
for 1GR-FE: Engine / Hybrid System>1GR-FE (FUEL)>FUEL TANK>REMOVAL
for 1VD-FTV: Engine / Hybrid System>1VD-FTV (FUEL)>FUEL TANK>REMOVAL
for 3UR-FE: Engine / Hybrid System>3UR-FE (FUEL)>FUEL TANK>REMOVAL
for 1UR-FE: Engine / Hybrid System>1UR-FE (FUEL)>FUEL TANK>REMOVAL
46430
8.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Remove the bolt and disconnect the No. 3 parking brake cable.
46420
9.DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
Remove the bolt and disconnect the No. 2 parking brake cable.
42306
10.DISCONNECT REAR AXLE BREATHER HOSE SUB-ASSEMBLY
Disconnect the rear axle breather hose from the rear axle housing assembly.
11.DISCHARGE SUSPENSION FLUID PRESSURE (w/ Active Height Control)
12.SUPPORT REAR AXLE HOUSING ASSEMBLY
Support the rear axle housing with a jack using a wooden block to avoid damage.
48740
13.DISCONNECT REAR LATERAL CONTROL ROD ASSEMBLY
Remove the bolt and nut, and disconnect the rear lateral control rod from the frame.
48530
14.DISCONNECT REAR SHOCK ABSORBER ASSEMBLY RH
Remove the bolt on the lower side of the shock absorber.
Disconnect the shock absorber from the axle housing.
49164B
15.DISCONNECT NO. 4 SUSPENSION CONTROL PRESSURE HOSE (w/ Active Height Control)
Remove the 2 bolts and disconnect the pressure hose from the shock absorber.
48540
16.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH (w/ Active Height Control)
Remove the bolt on the lower side of the shock absorber.
Using SST, hold the rear shock absorber in place.
Remove the nut, upper bracket and shock absorber assembly.
Remove the lower bracket from the shock absorber.
48540
17.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH (w/o Active Height Control)
Remove the bolt on the lower side of the shock absorber.
Using SST, hold the rear shock absorber in place.
Remove the nut, upper bracket and shock absorber assembly.
Remove the lower bracket from the shock absorber.