Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2014.08–2015.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255402 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2191/91  Vehicle Speed Signal Error (Test Mode DTC)  


DESCRIPTION

The tire pressure warning ECU and receiver receives speed signals from the combination meter assembly via CAN communication. This DTC is stored upon entering test mode (signal check mode), and cleared when a vehicle speed signal of 20 km/h (12 mph) is detected for 3 seconds or more. This DTC is output only in test mode (signal check mode).

DTC No. DTC Detection Condition Trouble Area
C2191/91 Speed sensor circuit malfunction
·

CAN communication system

·

Vehicle speed signal circuit

·

Combination meter assembly

·

Tire pressure warning ECU and receiver



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG) and turn the GTS on.


d.

Enter the following menus: "CAN Bus Check" from the "System Select" screen.


e.

Check the CAN communication system (for LHD: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM, for RHD: See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM).

OK:

The CAN communication system is normal.


Result:
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C




A

2.CHECK VEHICLE SPEED SIGNAL (DATA LIST)

B

C

2.CHECK VEHICLE SPEED SIGNAL (DATA LIST)
a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG) and turn the GTS on.


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


e.

Check that the values indicated on the GTS and on the combination meter assembly are the same.

Tire Pressure Monitor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Vehicle Speed Vehicle speed reading/
min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)
Actual vehicle speed Speed indicated on the combination meter assembly

OK:

The vehicle speed displayed on the GTS changes depending on the actual vehicle speed.




OK

3.CHECK TEST MODE DTC (C2191/91)

NG

3.CHECK TEST MODE DTC (C2191/91)
a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / Tire Pressure Monitor / Utility / Signal Check.


f.

Perform the test mode inspection (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>TEST MODE PROCEDURE).

Result:
Result Proceed to
DTC C2191/91 is not cleared A
DTC C2191/91 is cleared B




A

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

B