89183A
1.INSTALL YAW RATE SENSOR
Connect the sensor connector, and then attach the clamp to the hole of the sensor bracket.
Securely connect the connector.
Install the yaw rate sensor with the 2 bolts.
Make sure that the sensor is oriented correctly.
If the sensor is dropped, replace it.
When installing the sensor, make sure to avoid impacts to the sensor.
88520
2.INSTALL COOLING BOX ASSEMBLY (w/ Cool Box)
58901A
3.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (w/o Cool Box)
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
89183A
5.PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
Perform the yaw rate sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
89183A
6.CHECK YAW RATE SENSOR SIGNAL
Check the yaw rate sensor signal (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE).