Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › SKID CONTROL BUZZER › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255410 SKID CONTROL BUZZER A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  SKID CONTROL BUZZER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Other than areas where instructions are provided, use the same procedures for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 86652A 1.INSTALL SKID CONTROL BUZZER ASSEMBLY (for LHD)

a.
C170922

Connect the buzzer connector.

NOTICE:

Securely connect the connector.



b.

Attach the clamp to install the buzzer.

NOTICE:
·

Securely insert the clamp into the bracket.

·

If the buzzer is dropped, replace it.




Hide 86652A 2.INSTALL SKID CONTROL BUZZER ASSEMBLY (for RHD)

a.
C172844

Connect the buzzer connector.

NOTICE:

Securely connect the connector.



b.

Attach the clamp to install the buzzer.

NOTICE:
·

Securely insert the clamp into the bracket.

·

If the buzzer is dropped, replace it.




Hide 55432D 4.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 28800 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).