Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255415 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1433  Steering Angle Sensor Internal Circuit  


DESCRIPTION

Steering sensor signals are sent to the skid control ECU (master cylinder solenoid) via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering sensor zero point malfunction diagnostic function.

DTC Code DTC Detection Condition Trouble Area
C1433 Either condition is met:
1.

With the IG1 terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering sensor for 0.012 seconds.

2.

An open in the sensor power supply circuit for 1 second or more.


Steering sensor

CAUTION / NOTICE / HINT

HINT:

When any of the speed sensors or the yaw rate and acceleration sensor has trouble, DTCs for the steering sensor may be stored even when the steering sensor is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (airbag sensor assembly) are output together with DTCs for the steering sensor, inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag sensor assembly) first, and then inspect and repair the steering sensor.



PROCEDURE

1.REPLACE STEERING SENSOR
a.

Replace the steering sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL).

NOTICE:

When replacing the steering sensor confirm that the replacement part is of the correct specification.




NEXT

END