w/o Entry and Start System:
When CRAWL starts after operating the CRAWL ON/OFF switch / CRAWL speed selector switch (suspension control switch), the CRAWL indicator light turns on. While CRAWL is in the process of stopping, the CRAWL indicator light begins blinking. When CRAWL totally stops, the CRAWL indicator light turns off.
w/ Entry and Start System:
When CRAWL starts after operating the CRAWL ON/OFF switch / CRAWL speed selector switch / multi-terrain select mode switch* (integration control and panel assembly), the CRAWL indicator light turns on. While CRAWL is in the process of stopping, the CRAWL indicator light begins blinking. When CRAWL totally stops, the CRAWL indicator light turns off.
*: w/ Multi-terrain Select
When crawl control is activated with all of the crawl control activation conditions fulfilled during multi-terrain select control and the accelerator pedal is depressed, the multi-terrain select indicator light and crawl indicator light illuminate and multi-terrain select control enters "AUTO" mode. When the accelerator pedal is released, the multi-terrain select indicator light and crawl indicator light illuminate and crawl control begins.
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
A
B
C
D
E
A
B
C
D
E
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Crawl Control Light | CRAWL indicator light | Indicator light ON/OFF | Observe the combination meter assembly. |
When performing the Crawl Control Light Active Test, check Crawl Control Light in the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Crawl Control Light | CRAWL indicator light/ ON or OFF | ON: Indicator light on
OFF: Indicator light off |
- |
| Result | Proceed to | |
|---|---|---|
| Data List Display | Data List Display when Performing Active Test ON/OFF Operation | |
| ON | Changes between ON and OFF | A |
| Does not change between ON and OFF (for LHD) | B | |
| Does not change between ON and OFF (for RHD) | C | |
| OFF | Changes between ON and OFF | A |
| Does not change between ON and OFF (for LHD) | B | |
| Does not change between ON and OFF (for RHD) | C | |
A
(See pageVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C