The skid control ECU (master cylinder solenoid) receives signals from the deceleration sensor.
The DTCs are also stored when the calibration has not been completed.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1336 | Zero point calibration of the deceleration sensor is incomplete. | ·
Zero point calibration incomplete ·
Sensor installation ·
Deceleration sensor ·
Skid control ECU (Master cylinder solenoid) |
Refer to DTCs C1243, C1245, C1381 and C1418 (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>C1243).
After replacing the master cylinder solenoid, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).
After replacing the deceleration sensor, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).
Perform zero point calibration of the deceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).
NEXT
Turn the ignition switch off.
Perform the signal check in the Test Mode Procedure (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE).
All test mode DTCs are cleared.
OK
NG
Turn the ignition switch off.
Check that the deceleration sensor has been installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>DECELERATION SENSOR (w/ ABS)>INSTALLATION).
The sensor is tightened to the specified torque.
The sensor is not installed at an angle.
OK
NG
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Deceleration Sensor | Deceleration sensor/ Min.: -18.525 m/s2, Max.: 18.387 m/s2 | - | Changes continuously during acceleration/deceleration. |
Check that the deceleration sensor output value is displayed on the GTS.
Deceleration value changes.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (for LHD) | B |
| OK (for RHD) | C |
A
B
C