Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2015.08
RM2660E _54 Brake _052819 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0255416 ANTI-LOCK BRAKE SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  C1268  Transfer L4 Position Switch Circuit  


DESCRIPTION

DTC Code DTC Detection Condition Trouble Area
C1268 The skid control ECU receives an L4 abnormal status signal from the 4 wheel drive control ECU via CAN communication for 2 seconds or more.
·

Transfer system


·

Skid control ECU (Master cylinder solenoid)



CAUTION / NOTICE / HINT

NOTICE:

After replacing the master cylinder solenoid, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).


PROCEDURE

1.INSPECT TRANSFER L4 SHIFT
a.

Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.

OK:

There are no problems with the transfer system.




OK

2.RECONFIRM DTC

NG

GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE)

2.RECONFIRM DTC

b.

Turn the ignition switch off.


c.

Shift the transfer to L4, drive the vehicle, and then check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C



A

B

C