The brake fluid level warning switch (brake master cylinder reservoir sub-assembly) sends the appropriate signal to the skid control ECU (master cylinder solenoid) when the brake fluid level drops.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1453 | With the ECU terminal IG1 voltage at 10 to 14 V, an open in the brake fluid level warning switch circuit continues for 2 seconds or more. | ·
Brake fluid level ·
Brake fluid level warning switch (Brake master cylinder reservoir sub-assembly) ·
Harness or connector ·
Skid control ECU (Master cylinder solenoid) |
| C1454 | The fluid level of the reservoir is below the LOW level for 40 seconds after the ignition switch is turned to ON, or for 7 seconds during pump motor operation. |
After replacing the master cylinder solenoid, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>CALIBRATION).
Turn the ignition switch off.
Depress the brake pedal 40 times or more (until the pedal reaction feels light and pedal stroke becomes longer).
Check the amount of fluid in the brake reservoir.
When the ignition switch is turned to ON, brake fluid is sent to the accumulator and the fluid level decreases by approximately 5 mm (0.197 in.) from the level when the ignition switch is off (normal).
Brake fluid level is normal.
OK
NG
Disconnect the A26 brake fluid level warning switch (brake master cylinder reservoir sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
A float is placed inside the reservoir. Its position can be changed by increasing/decreasing the level of brake fluid.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (GND) - 2 (LBL) | Float UP (Switch off) | 1.9 to 2.1 kΩ |
| Float DOWN (Switch on) | Below 1 Ω |
| *a | Component without harness connected
(Brake Fluid Level Warning Switch [Brake Master Cylinder Reservoir Sub-assembly]) |
If there is no problem after finishing the above check, adjust the brake fluid level to the MAX level.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
A
B
C
Disconnect the A24 skid control ECU (master cylinder solenoid) connector.
Disconnect the A26 brake fluid level warning switch (brake master cylinder reservoir sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-41 (LBL) - A26-2 (LBL) | Always | Below 1 Ω |
| A24-41 (LBL) - Body ground | Always | 10 kΩ or higher |
| A26-1 (GND) - Body ground | Always | Below 1 Ω |
OK
NG
Clear the DTC (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Start the engine and idle it for approximately 40 seconds.
Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output (for LHD) | B |
| DTC is output (for RHD) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C