Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD) › 2014.08–2015.08
RM2660E _54 Brake _052820 BRAKE SYSTEM (OTHER) _0255425 BRAKE PEDAL(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION),


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55432D 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 47264A 8.REMOVE PUSH ROD PIN

a.
C172862

Remove the clip and push rod pin from the brake pedal lever.


Hide 84340 9.REMOVE STOP LIGHT SWITCH ASSEMBLY

a.

Disconnect the stop light switch connector.


b.

Remove the stop light switch (See page Vehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL).


Hide 10.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C229351

Loosen the hexagon bolt.

HINT:

Hold the bolt in place and loosen the nut.


NOTICE:

Only loosen the nut. Do not remove the bolt or nut.



b.

Remove the bolt from the brake pedal support reinforcement.


c.
C172861

Remove the 4 nuts and brake pedal support assembly.