Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Driver Side) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255606 KNEE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Driver Side)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RHD and LHD.

·

The procedures listed below are the LHD side.



PROCEDURE

Hide 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55449C 2.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55403C 3.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55474C 4.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55475A 5.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55606 6.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55432D 7.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 73900 8.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

a.

Remove the 5 bolts and driver side knee airbag.

B449541E01
0.438,0.052 1.219,0.292 0.781,0.24 12 false for LHD: 4.156,0.073 4.938,0.313 0.781,0.24 12 false for RHD:


b.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.