Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU (w/ Variable Flow Control Solenoid Valve) › from 2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255445 POWER STEERING ECU(w/ Variable Flow Control Solenoid Valve) A

POWER ASSIST SYSTEMS  POWER STEERING ECU(w/ Variable Flow Control Solenoid Valve)  INSTALLATION  


PROCEDURE

Hide 89650 1.INSTALL POWER STEERING ECU ASSEMBLY

a.

for LHD:

i.

Attach the claw and install the power steering ECU with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


ii.

Connect the connectors to the junction block.


iii.

Install the junction block with the bolt and nut.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)



b.

for RHD:

i.

Install the bolt and power steering ECU assembly to the junction block.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


ii.

Connect the connectors and attach the wire harness clamp to the junction block.


iii.

Install the junction block with the 2 nuts and bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)



Hide 55433B 2.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for LHD)

Hide 73900 4.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).