Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Driver Side) › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255606 KNEE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Driver Side)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 73900 1.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B427375E01
1.784,3.767 2.004,3.948 0.220,0.180 10 *a 2.569,3.692 1.986,3.855 false

Connect the airbag connector and lock the connector lock.

Text in Illustration
*a Connector Lock

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



d.

Install the driver side knee airbag assembly with the 5 bolts.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 55432D 2.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 55475A 3.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55474C 4.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55402C 5.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH (for Double Swing Out Type Back Door)

Hide 55403C 6.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH (except Double Swing Out Type Back Door)

Hide 55448A 7.INSTALL NO. 1 INSTRUMENT PANEL FINISH CUSHION (for Double Swing Out Type Back Door)

Hide 55449C 8.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION (except Double Swing Out Type Back Door)

Hide 62111C 9.INSTALL COWL SIDE TRIM BOARD RH (for Double Swing Out Type Back Door)

Hide 62112 10.INSTALL COWL SIDE TRIM BOARD LH (except Double Swing Out Type Back Door)

Hide 55606 11.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 67913B 12.INSTALL FRONT DOOR SCUFF PLATE RH (for Double Swing Out Type Back Door)

Hide 67914B 13.INSTALL FRONT DOOR SCUFF PLATE LH (except Double Swing Out Type Back Door)

Hide 55317A 14.INSTALL INSTRUMENT SIDE PANEL RH (for Double Swing Out Type Back Door)

Hide 55318C 15.INSTALL INSTRUMENT SIDE PANEL LH (except Double Swing Out Type Back Door)

Hide 16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 17. CHECK SRS WARNING LIGHT