Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING ECU (w/ Variable Flow Control Solenoid Valve) › from 2015.08
RM2660E _55 Steering _052824 POWER ASSIST SYSTEMS _0255445 POWER STEERING ECU(w/ Variable Flow Control Solenoid Valve) A

POWER ASSIST SYSTEMS  POWER STEERING ECU(w/ Variable Flow Control Solenoid Valve)  REMOVAL  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55433B 3.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for LHD)

Hide 55446A 4.REMOVE NO. 1 SWITCH HOLE BASE (for RHD)

Hide 73900 5.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

Hide 89650 6.REMOVE POWER STEERING ECU ASSEMBLY

a.

for LHD:

i.
C333715

Remove the bolt, nut and junction block.


ii.

Disconnect the connectors.


iii.
C333716

Remove the bolt, claw and power steering ECU assembly.



b.

for RHD:

i.

Remove the bolt and 2 nuts.

C335466


ii.

Disconnect the connectors and detach the wire harness clamp from the junction block.


iii.
C335469

Remove the bolt and power steering ECU assembly from the junction block.