Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Driver Side) › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255606 KNEE AIRBAG ASSEMBLY(for Driver Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Driver Side)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55317A 3.REMOVE INSTRUMENT SIDE PANEL RH (for Double Swing Out Type Back Door)

Hide 55318C 4.REMOVE INSTRUMENT SIDE PANEL LH (except Double Swing Out Type Back Door)

Hide 67913B 5.REMOVE FRONT DOOR SCUFF PLATE RH (for Double Swing Out Type Back Door)

Hide 67914B 6.REMOVE FRONT DOOR SCUFF PLATE LH (except Double Swing Out Type Back Door)

Hide 55606 7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62111C 8.REMOVE COWL SIDE TRIM BOARD RH (for Double Swing Out Type Back Door)

Hide 62112 9.REMOVE COWL SIDE TRIM BOARD LH (except Double Swing Out Type Back Door)

Hide 55448A 10.REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION (for Double Swing Out Type Back Door)

Hide 55449C 11.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION (except Double Swing Out Type Back Door)

Hide 55402C 12.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH (for Double Swing Out Type Back Door)

Hide 55403C 13.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH (except Double Swing Out Type Back Door)

Hide 55474C 14.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55475A 15.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55432D 16.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 73900 17.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

a.
B427374E03
0.927,3.719 1.24,3.938 false 1.292,3.896 1.594,4.125 0.302,0.229 10 false *a

Remove the 5 bolts and driver side knee airbag assembly.


b.

Using a screwdriver, release the connector lock and disconnect the airbag connector.

Text in Illustration
*a Connector Lock
V100155

Protective Tape

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.