The characteristics of the electronic throttle, PPS and automatic transmission change by operating the drive mode select switch (integration control & panel assembly).
Check for DTCs.
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output | A |
| CAN communication system DTCs are output (for LHD) | B |
| CAN communication system DTCs are output (for RHD) | C |
A
B
C
Turn the engine switch off.
Disconnect the V8 drive mode select switch (integration control & panel assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V8-5 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Drive mode select switch (integration control & panel assembly)) |
OK
NG
Inspect drive mode select switch (integration control & panel assembly).
for AE80F: See page Drivetrain>AE80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>COMBINATION SWITCH>INSPECTION.
Drive mode select switch (integration control & panel assembly) is normal.
| Result | Proceed to | |
|---|---|---|
| OK | A | |
| NG | for AB60F | B |
| for AE80F | C | |
A
B
C
Reconnect the V8 drive mode select switch (integration control & panel assembly) connector.
Disconnect the A38*1 or A52*2 ECM connector.
*1: except 1VD-FTV (w/o DPF) (for RHD)
*2: for 1VD-FTV (w/o DPF) (for RHD)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-34 (PWMS) - Body ground | SPORT mode switch being turned and held | Below 50 Ω |
| A38-34 (PWMS) - Body ground | SPORT mode switch not turned | 10 kΩ or higher |
| A38-49 (SPCN) - Body ground | NORMAL mode switch being pushed and held | Below 50 Ω |
| A38-49 (SPCN) - Body ground | NORMAL mode switch not pushed | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-39 (PWMS) - Body ground | SPORT mode switch being turned and held | Below 50 Ω |
| A38-39 (PWMS) - Body ground | SPORT mode switch not turned | 10 kΩ or higher |
| A38-22 (SPCN) - Body ground | NORMAL mode switch being pushed and held | Below 50 Ω |
| A38-22 (SPCN) - Body ground | NORMAL mode switch not pushed | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-39 (PWMS) - Body ground | SPORT mode switch being turned and held | Below 50 Ω |
| A38-39 (PWMS) - Body ground | SPORT mode switch not turned | 10 kΩ or higher |
| A38-43 (SPCN) - Body ground | NORMAL mode switch being pushed and held | Below 50 Ω |
| A38-43 (SPCN) - Body ground | NORMAL mode switch not pushed | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-39 (PWMS) - Body ground | SPORT mode switch being turned and held | Below 50 Ω |
| A38-39 (PWMS) - Body ground | SPORT mode switch not turned | 10 kΩ or higher |
| A38-43 (SPCN) - Body ground | NORMAL mode switch being pushed and held | Below 50 Ω |
| A38-43 (SPCN) - Body ground | NORMAL mode switch not pushed | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A52-39 (PWMS) - Body ground | SPORT mode switch being turned and held | Below 50 Ω |
| A52-39 (PWMS) - Body ground | SPORT mode switch not turned | 10 kΩ or higher |
| A52-43 (SPCN) - Body ground | NORMAL mode switch being pushed and held | Below 50 Ω |
| A52-43 (SPCN) - Body ground | NORMAL mode switch not pushed | 10 kΩ or higher |
| *A | for 3UR-FE |
| *B | for 1UR-FE |
| *C | for 1VD-FTV |
| *D | except 1VD-FTV (w/o DPF) (for RHD) |
| *E | for 1VD-FTV (w/o DPF) (for RHD) |
| *a | Front view of wire harness connector
(to ECM) |
| Result | Proceed to | |
|---|---|---|
| OK | for 1UR-FE | A |
| for 3UR-FE | B | |
| for 1VD-FTV | C | |
| NG | D | |
A
B
C
D