Home › Steering › VARIABLE GEAR RATIO STEERING › VARIABLE GEAR RATIO STEERING SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255448 VARIABLE GEAR RATIO STEERING SYSTEM C

VARIABLE GEAR RATIO STEERING  VARIABLE GEAR RATIO STEERING SYSTEM  C15C3/75  Brake System Control Module Malfunction  


DESCRIPTION

The steering control ECU detects a vehicle speed error by receiving an error signal from the skid control ECU via CAN communication.

If the steering control ECU detects this error signal, it will turn the master warning light on, store this DTC, and stop VGRS operation.

DTC Code DTC Detection Condition Trouble Area
C15C3/75 The steering control ECU receives a vehicle speed error signal via CAN communication.
·

Vehicle stability control system

·

CAN communication system

·

Steering control ECU



PROCEDURE

1.CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for DTCs in the vehicle stability control system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output OK
DTC is output NG



OK

2.CHECK DTC (CAN COMMUNICATION SYSTEM)

NG

GO TO VEHICLE STABILITY CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

2.CHECK DTC (CAN COMMUNICATION SYSTEM)
a.

Using the intelligent tester, check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM for LHD, Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM for RHD).

Result
Result Proceed to
DTC is not output (for LHD) A
DTC is not output (for RHD) B
DTC is output (for LHD) C
DTC is output (for RHD) D



A

B

C

GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

D

GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)