Home › Steering › VARIABLE GEAR RATIO STEERING › STEERING CONTROL ECU (for RHD) › 2014.08–2015.08
RM2660E _55 Steering _052825 VARIABLE GEAR RATIO STEERING _0255451 STEERING CONTROL ECU(for RHD) A

VARIABLE GEAR RATIO STEERING  STEERING CONTROL ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:
·

After the engine switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 55317A 2.REMOVE INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)

Hide 55317A 3.REMOVE INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)

Hide 55474C 4.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55475A 5.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 67913B 6.REMOVE FRONT DOOR SCUFF PLATE RH (w/o Sliding Roof)

Hide 67913B 7.REMOVE FRONT DOOR SCUFF PLATE RH (w/ Sliding Roof)

Hide 55606 8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55432D 10.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 73900 12.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55303B 13.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

Hide 14.REMOVE STEERING CONTROL ECU WITH JUNCTION BLOCK

C358505E01
0.177,0.125 1.708,0.323 1.531,0.198 10 false Rear Side: 4.552,0.125 6.083,0.323 1.531,0.198 10 false Front Side:

a.

Rear side:

i.

Disconnect the 2 connectors.


ii.

Remove the bolt and 2 nuts.



b.

Front side:

i.

Disconnect the 3 connectors.



c.

Remove the steering control ECU with the junction block.


Hide 89181A 15.REMOVE STEERING CONTROL ECU

a.
C172818

Remove the 2 bolts and separate the steering control ECU from the junction block.