Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM › 2014.08–2015.08
RM2660E _55 Steering _052826 STEERING COLUMN _0255452 STEERING LOCK SYSTEM C

STEERING COLUMN  STEERING LOCK SYSTEM  B2781  Open / Short in Steering Lock ECU  


DESCRIPTION

The steering lock ECU and steering lock actuator assembly are supplied as a unit.

The steering lock ECU detects the steering lock position through the signals from the lock and unlock position sensors.

The steering lock ECU activates the steering lock motor based on permission signals from the main body ECU and the certification ECU (smart key ECU assembly).

The diagnosis information of the steering lock ECU is transmitted to the intelligent tester via the certification ECU (smart key ECU assembly) as the steering lock ECU is not connected to the CAN communication system.

DTC Code Detection Condition Trouble Area
B2781 When either condition below is met:
·

Steering lock motor drive power circuit malfunction

·

Lock and unlock position sensors ON condition is detected


·

Steering lock actuator assembly (steering lock ECU)

·

Certification ECU (smart key ECU assembly)

·

Harness or connector of LIN bus line



CAUTION / NOTICE / HINT

HINT:

When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following steps to wake up the ECU:

With the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.


PROCEDURE

1.CHECK DTC OUTPUT (B2785)
a.

Check for DTCs.

Result
Result Proceed to
DTC B2781 is output, but DTC B2785 is not output (for Power tilt and telescopic) A
Condition other than following:
DTC B2781 is output, but DTC B2785 is not output
B
DTC B2781 is output, but DTC B2785 is not output (for Manual tilt and telescopic) C



A

B

GO TO LIN COMMUNICATION SYSTEM (DTC B2785)

C