Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84255
1.INSTALL STEERING HEATER SWITCH
Attach the 2 claws to install the steering heater switch to the lower instrument panel finish panel sub-assembly.
55446A
2.INSTALL NO. 1 SWITCH HOLE BASE
55432D
3.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55606
4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55475A
5.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55474C
6.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55403C
7.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55449C
8.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).