Home › Audio / Visual / Telematics › AUDIO / VIDEO › INSTRUMENT PANEL SPEAKER › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255470 INSTRUMENT PANEL SPEAKER A

AUDIO / VIDEO  INSTRUMENT PANEL SPEAKER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 86160P 1.INSTALL FRONT NO. 2 SPEAKER ASSEMBLY

a.

Connect the connector.

E336733E01
0.145,0 1.912,0.482 1.767,0.482 12 for 9 Speakers: 2.55,0 4.317,0.482 1.767,0.482 12 for 14 Speakers: 4.995,0 6.762,0.482 1.767,0.482 12 for 4, 6 Speakers:


b.

Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.


c.

Install the speaker with the 2 bolts.

NOTICE:
·

Do not touch the cone part of the speaker.

·

When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.




Hide 55408F 2.INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

Hide 86160L 5.INSTALL FRONT NO. 4 SPEAKER ASSEMBLY

a.

Connect the speaker connector.


b.

Temporarily install the speaker by aligning the positioning pins of the speaker with the instrument panel.


c.

Install the speaker with the 2 bolts.

E336732E01
0.029,0 2.079,0.564 2.050,0.564 12 for 9 Speakers: 3.588,0 5.638,0.564 2.050,0.564 12 for 14 Speakers:

NOTICE:
·

Do not touch the cone part of the speaker.

·

When installing the speaker to the instrument panel be careful that the wires do not get caught between the parts.




Hide 55510F 6.INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).