Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255474 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 63310 3.REMOVE ROOF HEADLINING ASSEMBLY

a.

w/o Sliding Roof:

Remove the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>REMOVAL).


b.

w/ Sliding Roof:

Remove the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>REMOVAL).


Hide 86101S 4.REMOVE ANTENNA CORD SUB-ASSEMBLY

a.

w/o Sliding Roof:

i.

Detach the 2 clamps and remove the antenna from the notch on the rear of the roof headlining.

B181735


ii.

Remove the antenna cord from the roof headlining.


iii.

Remove the double-sided tape from the roof headlining.



b.

w/ Sliding Roof:

i.

Detach the 4 clamps and remove the antenna from the notch on the rear of the roof headlining.

B181736


ii.

Remove the antenna cord from the roof headlining.


iii.

Remove the double-sided tape from the roof headlining.



Hide 55400 5.REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

a.

Remove the instrument panel safety pad (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL).


Hide 86101 6.REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Multi-display)

a.

for LHD:

Detach the 8 clamps and remove the antenna cord.

B181729


b.

for RHD:

Detach the 6 clamps and remove the antenna cord.

B181731


Hide 86101 7.REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o Multi-display)

a.

for LHD:

Detach the 7 clamps and remove the antenna cord.

B181730


b.

for RHD:

Detach the 5 clamps and remove the antenna cord.

B181732