This DTC is stored when a malfunction occurs in the television display assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15B0 | When either condition below is met:
·
Picture circuit (TFT unit) malfunction ·
Back light malfunction (excess current) |
·
Television display assembly ·
Multi-display assembly |
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).
NEXT
Recheck for DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B15B0 is not output. | A |
| DTC B15B0 is output. | B |
This DTC is output from the multi-media module receiver assembly or television display assembly.
When the DTC is checked using the intelligent tester, whether the DTC is output from the multi-media module receiver assembly, or whether it is output from the television display assembly, cannot be distinguished. For this reason, recheck the DTC using the "System Check Mode" screen.
Enter diagnostic mode and display the "Service Menu" screen (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).
Select "Failure Diagnosis Service Check" on the "Service Menu" screen to display the "Failure Diagnosis Service Check" screen.
Select "Service Check Mode" on the "Failure Diagnosis Service Check" screen and perform the service check.
Recheck for DTCs and proceed to the next step according to the table below (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output from the multi-media module receiver assembly. | B |
| DTC is output from a television display assembly. | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C