The multi-media module receiver assembly and multi-display controller sub-assembly are connected by a MOST communication line.
When a MOST communication error occurs between the multi-media module receiver assembly and multi-display controller sub-assembly, these DTCs will be stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15D5* | A device that is listed in the MOST network connected device record of the master unit is missing. | ·
MOST communication line ·
Multi-media module receiver assembly ·
Multi-display controller sub-assembly ·
Harness or connector |
*: Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
The multi-media module receiver assembly is the master unit.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).
NEXT
Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the multi-display controller sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L67-14 (GND) - Body ground | Always | Below 1 Ω |
| L67-15 (GND5) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L67-1 (+B) - Body ground | Always | 11 to 14 V |
| L67-6 (+B2) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector
(to Multi-display Controller Sub-assembly) |
OK
NG
Disconnect the F102 multi-media module receiver assembly connector.
Disconnect the L77 multi-display controller sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F102-2 (MI+) - L77-5 (MO+) | Always | Below 1 Ω |
| F102-3 (MI-) - L77-6 (MO-) | Always | Below 1 Ω |
| F102-4 (SLDI) - L77-7 (SLDO) | Always | Below 1 Ω |
| F102-2 (MI+) or L77-5 (MO+) - Body ground | Always | 10 kΩ or higher |
| F102-3 (MI-) or L77-6 (MO-) - Body ground | Always | 10 kΩ or higher |
| F102-4 (SLDI) or L77-7 (SLDO) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the multi-display controller sub-assembly with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT ECU>REMOVAL).
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).
NEXT
Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
NG