Enter diagnostic mode.
Press preset switch "2" to change the mode to "Detailed Information Mode".
Identify the component shown by the sub-code.
"P190" set by the radio receiver assembly is shown in the preceding illustration as an example.
For details of the DTC display, refer to DTC Check/Clear (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/o Navigation System)>DTC CHECK / CLEAR).
NEXT
Select the component shown by the sub-code.
| Component | Proceed to |
|---|---|
| Except radio receiver assembly | A |
| Radio receiver assembly (190) | B |
A
B
Inspect the power source circuit of the component shown by the sub-code.
If the power source circuit is operating normally, proceed to the next step.
NEXT
Disconnect the F1 and F55 radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F1-5 (ATX+) - F1-15 (ATX-) | Always | 60 to 80 Ω |
| F55-9 (TXM+) - F55-10 (TXM-) | Always | 60 to 80 Ω |
| *1 | Component without harness connected
(Radio Receiver Assembly) |
| *2 | Component without harness connected
(Radio Receiver Assembly) |
OK
NG
Start the check from the circuit that is near the component shown by the sub-code first.
For details of the connectors, refer to Terminals of ECU (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/o Navigation System)>TERMINALS OF ECU).
Referring to the following AVC-LAN wiring diagram, check the AVC-LAN circuit between the radio receiver assembly and component shown by the sub-code.
Disconnect all connectors between the radio receiver assembly and component shown by the sub-code.
Check for an open or short in the AVC-LAN circuit between the radio receiver assembly and component shown by the sub-code.
There is no open or short circuit.
OK
NG
Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.
Malfunction disappears.
OK
NG