This DTC is stored when the hard disc which is built into the multi-media module receiver assembly has an initialization malfunction or read/write errors occur more than a specified number of times.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15B8 | Hard Disk Drive (HDD) malfunction | Hard disc |
Enter the "Failure Diagnosis" screen. [Refer to Check Hard Disc in Operation Check (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (w/ Multi-display)>OPERATION CHECK)]
Select "HDD Check" and check the result.
"OK" is displayed.
After selecting "HDD Check", it may take a while until the result is displayed.
If the cabin temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher, the hard disc may not operate normally, and "NG" may be shown on the display. Make sure to perform the inspection with the cabin at an appropriate temperature.
| *a | Result |
OK
NG
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
NEXT
Recheck for DTCs and check if the same DTCs are output again (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
No DTCs are output.
The hard disc may be malfunctioning even if DTC B15B8 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Replace the hard disc with a new or known good one (See page Audio / Visual / Telematics>AUDIO / VIDEO>HARD DISK DRIVE>REMOVAL).
NEXT
Clear the DTCs (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
NEXT
Recheck for DTCs and check if the same DTCs are output again (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (w/ Multi-display)>DTC CHECK / CLEAR).
No DTCs are output.
The hard disc may be malfunctioning even if DTC B15B8 is not output.
OK
NG