Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › MULTI-DISPLAY (w/ Navigation System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255491 MULTI-DISPLAY(w/ Navigation System) A

NAVIGATION / MULTI INFO DISPLAY  MULTI-DISPLAY(w/ Navigation System)  INSTALLATION  


PROCEDURE

Hide 86211J 1.INSTALL NO. 1 RADIO RECEIVER BRACKET

a.

Install the No.1 radio receiver bracket with the 4 bolts.

Torque:
3.0 N*m (30 kgf*cm, 26 in.*lbf)


Hide 86111 2.INSTALL MULTI-DISPLAY ASSEMBLY

a.

Connect the connectors.


b.
E249496

Insert the multi-display assembly and attach the 2 clips and 6 claws on its backside.

NOTICE:

When inserting the multi-display assembly, do not press the knobs on it.



c.
E247526E01
0.84,2.626 1.04,2.845 0.2,0.219 0.877,2.657 0.995,2.803 0.118,0.145 10 A 2.44,2.705 2.64,2.924 0.2,0.219 2.477,2.736 2.595,2.881 0.118,0.145 10 A

Install the multi-display assembly with the 2 screws and 2 bolts.

Torque:
Bolt A : 12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 55680A 3.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55670 4.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55510F 5.INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).