Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the multi-media module receiver assembly.

WIRING DIAGRAM

E250925E02
5.06,2.008 6.336,2.374 1.276,0.366 10 Multi-media Module Receiver Assembly 5.06,1.826 5.354,1.977 0.293,0.151 10 F77 2.658,1.377 2.959,1.543 0.301,0.166 10 E53 2.658,1.545 3.787,1.926 1.129,0.381 10 Parking Brake Switch Assembly 5.405,1.058 5.759,1.239 0.354,0.181 10 PKB 5.167,0.974 5.359,1.143 0.192,0.168 10 55 3.682,0.974 3.818,1.143 0.137,0.168 10 1

PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
U116554E01
0.128,1.122 0.311,1.193 0.183,0.071 0.128,1.122 0.311,1.193 0.183,0.071

Enter the "Function Check/Setting I" mode and select "Vehicle Signal" (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK).


b.

Check that the display changes between ON and OFF according to the parking brake operation.

OK:
Parking Brake Position Display
Applied ON
Released OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - MULTI-MEDIA MODULE RECEIVER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - MULTI-MEDIA MODULE RECEIVER ASSEMBLY)
a.

Disconnect the E53 parking brake switch assembly connector.


b.

Disconnect the F77 multi-media module receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F77-55 (PKB) - E53-1 Always Below 1 Ω
F77-55 (PKB) - Body ground Always 10 kΩ or higher




OK

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.
E248885

Remove the parking brake switch assembly connector (See page Brake>PARKING BRAKE>PARKING BRAKE LEVER>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 - Switch body ON (Shaft not pressed) Below 1 Ω
OFF (Shaft pressed) 10 kΩ or higher


Text in Illustration
V100135

ON
V100136

OFF



OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY