Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Illumination for Panel Switch does not Come on with Tail Switch ON  


CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION).


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.

Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK)]


E278187

b.

Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.

OK:
Light Control Switch Display
Tail or head ON
Off OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



c.

Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the light control switch operation.

OK:
Light Control Switch Display
Tail or head DIM
Off BRIGHT




OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE