Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Display does not Dim when Light Control Switch is Turned ON  


CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION).


PROCEDURE

1.CHECK IMAGE QUALITY SETTING
a.

Display the "Display" screen.


b.

Turn the light control switch to the tail or head position.


c.

Check if "Day Mode" on the display adjustment screen is on.

OK:

"Day Mode" setting is off




OK

2.CHECK VEHICLE SIGNAL (OPERATION CHECK)

NG

TURN "Day Mode" SETTING OFF

2.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.

Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK)]


E278187

b.

Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.

OK:
Light Control Switch Display
Tail or head ON
Off OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.



c.

Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the light control switch operation.

OK:
Light Control Switch Display
Tail or head DIM
Off BRIGHT




OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE