Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B15D5  Rear Seat Entertainment System Disconnected  


DESCRIPTION

The multi-media module receiver assembly and television display assembly are connected by the MOST communication line.

When a MOST communication error occurs between the multi-media module receiver assembly and television display assembly, these DTCs will be stored.

DTC Code DTC Detection Condition Trouble Area
B15D5 A device that is listed in the MOST network connected device record of the master unit is missing.
·

Television display assembly power source circuit

·

MOST circuit between stereo component amplifier assembly and television display assembly

·

MOST circuit between television display assembly and multi-media module receiver assembly

·

Television display assembly

·

Multi-media module receiver assembly



HINT:

For the MOST network, the multi-media module receiver assembly is the master unit.


WIRING DIAGRAM

E248829E03
1.833,0.646 2.146,0.813 0.313,0.167 10 false RSE 0.354,0.479 1.156,0.667 0.802,0.188 10 false from Battery 2.771,0.5 3.042,0.656 0.271,0.156 10 false L53 2.75,0.917 3.021,1.073 0.271,0.156 10 false L53 2.781,0.271 2.979,0.417 0.198,0.146 10 false 11 2.823,0.719 2.979,0.865 0.156,0.146 10 false 1 4.188,0.49 4.458,0.646 0.271,0.156 10 false L53 4.188,0.906 4.5,1.094 0.313,0.188 10 false L53 4.24,0.302 4.396,0.448 0.156,0.146 10 false 3 4.24,0.698 4.396,0.844 0.156,0.146 10 false 4 4.188,1.667 4.458,1.823 0.271,0.156 10 false L56 4.177,2.073 4.448,2.229 0.271,0.156 10 false L56 4.26,1.427 4.417,1.573 0.156,0.146 10 false 5 4.26,1.875 4.417,2.021 0.156,0.146 10 false 6 4.198,2.479 4.469,2.635 0.271,0.156 10 false L56 4.26,2.302 4.417,2.448 0.156,0.146 10 false 7 2.76,1.635 3.031,1.792 0.271,0.156 10 false L56 2.75,2.073 3.021,2.229 0.271,0.156 10 false L56 2.833,1.438 2.99,1.583 0.156,0.146 10 false 2 2.833,1.885 2.99,2.031 0.156,0.146 10 false 3 2.75,2.49 3.021,2.646 0.271,0.156 10 false L56 2.833,2.313 2.99,2.458 0.156,0.146 10 false 4 1.646,1.5 1.802,1.646 0.156,0.146 10 false 5 1.646,1.948 1.802,2.094 0.156,0.146 10 false 6 1.646,2.375 1.802,2.521 0.156,0.146 10 false 7 3.135,0.479 3.427,0.677 0.292,0.198 10 false +B2 3.135,0.906 3.406,1.094 0.271,0.188 10 false +B 3.729,0.469 4.104,0.646 0.375,0.177 10 false GND 3.667,0.917 4.083,1.146 0.417,0.229 10 false GND2 5.594,1.646 5.865,1.833 0.271,0.188 10 false MI+ 5.604,2.021 5.875,2.208 0.271,0.188 10 false MI- 5.583,2.427 5.938,2.615 0.354,0.188 10 false SLDI 3.125,1.583 3.396,1.771 0.271,0.188 10 false MI+ 3.125,1.99 3.396,2.177 0.271,0.188 10 false MI- 3.125,2.427 3.479,2.615 0.354,0.188 10 false SLDI 3.76,1.625 4.094,1.813 0.333,0.188 10 false MO+ 3.76,2.052 4.094,2.24 0.333,0.188 10 false MO- 3.677,2.479 4.073,2.667 0.396,0.188 10 false SLDO 1.26,1.583 1.594,1.771 0.333,0.188 10 false MO+ 1.26,1.99 1.594,2.177 0.333,0.188 10 false MO- 1.198,2.427 1.594,2.615 0.396,0.188 10 false SLDO 5.427,1.49 5.563,1.688 0.135,0.198 10 false 2 5.427,1.927 5.563,2.125 0.135,0.198 10 false 3 5.427,2.344 5.563,2.542 0.135,0.198 10 false 4 0.469,2.854 0.74,3.021 0.271,0.167 10 false F85 0.458,3.042 1.74,3.406 1.281,0.365 10 false Stereo Component Amplifier Assembly 5.438,2.875 5.708,3.042 0.271,0.167 10 false F84 5.417,3.042 6.698,3.417 1.281,0.375 10 false Multi-media Module Receiver Assembly 3.01,2.885 4.281,3.229 1.271,0.344 10 false Television Display Assembly 1.865,2.667 2.438,2.833 0.573,0.167 10 false Shielded 4.781,2.688 5.354,2.854 0.573,0.167 10 false Shielded

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)
a.

Check for optional components.

i.

Check that optional components (including associated wiring) which generate radio waves are not installed.

Result
Result Proceed to
Optional components (including associated wiring) are installed. A
Optional components (including associated wiring) are not installed. B

HINT:
·

Electrical noise from radio waves generated by optional components or the wiring for those components may affect MOST communication.

·

This DTC may be stored when a MOST communication error occurs due to electrical noise.






A

2.REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)

B

3.CLEAR DTC
2.REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)
a.

Remove optional components (including associated wiring).

NOTICE:

Do not remove optional components or associated wiring without the permission of the customer.




NEXT

3.CLEAR DTC
4.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.




OK

END (COMMUNICATION MALFUNCTION DUE TO NOISE)

NG

5.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND)
5.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY AND BODY GROUND)
a.
U166308E01
0.12,0.044 0.355,0.228 0.235,0.184 10 *a 0.534,1.614 0.820,1.772 0.286,0.157 10 +B2 0.264,0.569 0.530,0.742 0.266,0.173 10 L53 1.493,1.788 1.930,1.972 0.438,0.184 10 GND2 0.423,1.292 0.650,1.464 0.227,0.173 10 +B 0.939,1.817 1.310,1.970 0.371,0.153 10 GND 1.074,1.436 0.895,1.677 false 1.546,1.258 1.719,1.745 false 1.329,1.258 1.165,1.773 false 1.05,1.234 0.698,1.378 false

Disconnect the television display assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L53-3 (GND) - Body ground Always Below 1 Ω
L53-4 (GND2) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L53-11 (+B2) - L53-3 (GND) Always 11 to 14 V
L53-1 (+B) - L53-3 (GND) Always 11 to 14 V



Text in Illustration
*a Front view of wire harness connector
(to Television Display Assembly)


OK

6.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the L56 television display assembly connector.


b.

Disconnect the F85 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L56-2 (MI+) - F85-5 (MO+) Always Below 1 Ω
L56-3 (MI-) - F85-6 (MO-) Always Below 1 Ω
L56-4 (SLDI) - F85-7 (SLDO) Always Below 1 Ω
L56-2 (MI+) - Body ground Always 10 kΩ or higher
L56-3 (MI-) - Body ground Always 10 kΩ or higher
L56-4 (SLDI) - Body ground Always 10 kΩ or higher




OK

7.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - MULTI-MEDIA MODULE RECEIVER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - MULTI-MEDIA MODULE RECEIVER ASSEMBLY)
a.

Disconnect the L56 television display assembly connector.


b.

Disconnect the F84 multi-media module receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L56-5 (MO+) - F84-2 (MI+) Always Below 1 Ω
L56-6 (MO-) - F84-3 (MI-) Always Below 1 Ω
L56-7 (SLDO) - F84-4 (SLDI) Always Below 1 Ω
L56-5 (MO+) - Body ground Always 10 kΩ or higher
L56-6 (MO-) - Body ground Always 10 kΩ or higher
L56-7 (SLDO) - Body ground Always 10 kΩ or higher




OK

8.REPLACE TELEVISION DISPLAY ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

8.REPLACE TELEVISION DISPLAY ASSEMBLY
a.

Replace the television display assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>TELEVISION DISPLAY>REMOVAL).



NEXT

9.CLEAR DTC
10.CHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).

OK:

No DTCs are output.




OK

END (TELEVISION DISPLAY ASSEMBLY IS DEFECTIVE)

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY