Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052829 NAVIGATION / MULTI INFO DISPLAY _0255494 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B158F  AV Signal Stoppage (Low Battery Voltage)  


DESCRIPTION

This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the multi-media module receiver assembly dropping temporarily.

DTC Code DTC Detection Condition Trouble Area
B158F A video or audio signal is interrupted when the battery voltage drops.
·

Multi-media module receiver assembly

·

Harness or connector



WIRING DIAGRAM

E280930E24
0.838,0.976 1.684,1.183 0.846,0.207 10 from Battery 3.323,1.163 3.850,1.347 0.527,0.184 10 RADIO 5.004,0.892 5.253,1.076 0.248,0.184 10 17 5.252,0.99 5.782,1.169 0.531,0.179 10 +B1 5.01,1.901 5.425,2.061 0.415,0.161 10 F77 5.01,2.05 6.300,2.387 1.290,0.336 10 Multi-media Module Receiver Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION).

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
E268487

Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK)]


b.

Check that the battery voltage.

Standard voltage:

11 to 14 V


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.




OK

2.CHECK DTC

NG

3.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY POWER SOURCE)
3.CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY POWER SOURCE)
a.
U166456E01
1.736,0.444 2.067,0.628 0.332,0.184 10 F77 2.95,0.662 3.282,0.846 0.332,0.184 10 +B1 0.2,0.089 0.532,0.273 0.332,0.184 10 *a 2.595,1.143 2.807,0.754 2.807,0.754 2.922,0.754 false

Disconnect the multi-media module receiver assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
F77-17 (+B1) - Body ground Always 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Multi-media Module Receiver Assembly)



OK

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR