Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255497 TOYOTA PARKING ASSIST-SENSOR SYSTEM C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  C1AEC  Front Sensor Communication Malfunction  


DESCRIPTION

This DTC is stored when there is an open or short circuit in the communication line between the front sensors and the ECU, or when there is a malfunction in a front sensor.

DTC Code DTC Detection Condition Trouble Area
C1AEC An open or short circuit in the communication line between the front sensors and ECU or a malfunction in a front sensor during initialization mode after the engine switch is turned on (IG).
·

No. 1 ultrasonic sensor (front side)

·

Harness or connector

·

Clearance warning ECU assembly



WIRING DIAGRAM

E326708E03
1.469,0.719 1.625,0.917 0.156,0.198 10 false 1 1.479,1.208 1.635,1.406 0.156,0.198 10 false 3 1.479,1.698 1.635,1.896 0.156,0.198 10 false 5 1.198,0.844 1.542,1.052 0.344,0.208 10 false BI 1.198,1.323 1.542,1.531 0.344,0.208 10 false SI 1.188,1.802 1.531,2.01 0.344,0.208 10 false EI 0.417,2.219 0.76,2.427 0.344,0.208 10 false B9 0.427,2.385 2.083,2.823 1.656,0.438 10 false No. 1 Ultrasonic Sensor (Front Corner Sensor RH) 3,0.719 3.156,0.917 0.156,0.198 10 false 2 3,1.198 3.156,1.396 0.156,0.198 10 false 4 2.99,1.688 3.146,1.885 0.156,0.198 10 false 6 3.219,0.844 3.563,1.052 0.344,0.208 10 false BO 3.208,1.323 3.552,1.531 0.344,0.208 10 false SO 3.229,1.813 3.573,2.021 0.344,0.208 10 false EO 3.813,0.833 4.156,1.042 0.344,0.208 10 false BI 3.813,1.313 4.156,1.521 0.344,0.208 10 false SI 3.823,1.802 4.167,2.01 0.344,0.208 10 false EI 4.104,0.719 4.26,0.917 0.156,0.198 10 false 1 4.104,1.208 4.26,1.406 0.156,0.198 10 false 3 4.115,1.688 4.271,1.885 0.156,0.198 10 false 5 5.615,0.719 5.771,0.917 0.156,0.198 10 false 4 5.625,1.198 5.781,1.396 0.156,0.198 10 false 8 5.635,1.677 5.792,1.875 0.156,0.198 10 false 6 5.844,0.823 6.323,1.042 0.479,0.219 10 false BOF 5.823,1.323 6.26,1.542 0.438,0.219 10 false SOF 5.823,1.792 6.354,1.969 0.531,0.177 10 false E5 2.958,2.198 3.302,2.406 0.344,0.208 10 false B10 2.958,2.365 4.625,2.802 1.667,0.438 10 false No. 1 Ultrasonic Sensor (Front Corner Sensor LH) 5.604,2.219 5.948,2.427 0.344,0.208 10 false F92 5.604,2.385 6.906,2.813 1.302,0.427 10 false Clearance Warning ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:

If DTCs are output after repairs, turn the engine switch on (IG) and turn the TOYOTA parking assist-sensor system on. Then clear the DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>DTC CHECK / CLEAR).


PROCEDURE

1.CHECK FOR DTC

A

B

2.CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR [FRONT CORNER SENSOR LH] - CLEARANCE WARNING ECU ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR [FRONT CORNER SENSOR LH] - CLEARANCE WARNING ECU ASSEMBLY)
a.

Disconnect the B10 No. 1 ultrasonic sensor (front corner sensor LH) connector.


b.

Disconnect the F92 clearance warning ECU assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F92-4 (BOF) - B10-1 (BI) Always Below 1 Ω
F92-8 (SOF) - B10-3 (SI) Always Below 1 Ω
F92-6 (E5) - B10-5 (EI) Always Below 1 Ω
F92-4 (BOF) - Body ground Always 10 kΩ or higher
F92-8 (SOF) - Body ground Always 10 kΩ or higher
F92-6 (E5) - Body ground Always 10 kΩ or higher




OK

3.CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR [FRONT CORNER SENSOR LH] - NO. 1 ULTRASONIC SENSOR [FRONT CORNER SENSOR RH])

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (NO. 1 ULTRASONIC SENSOR [FRONT CORNER SENSOR LH] - NO. 1 ULTRASONIC SENSOR [FRONT CORNER SENSOR RH])
a.

Disconnect the B10 No. 1 ultrasonic sensor (front corner sensor LH) connector.


b.

Disconnect the B9 No. 1 ultrasonic sensor (front corner sensor RH) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B10-2 (BO) - B9-1 (BI) Always Below 1 Ω
B10-4 (SO) - B9-3 (SI) Always Below 1 Ω
B10-6 (EO) - B9-5 (EI) Always Below 1 Ω
B10-2 (BO) - Body ground Always 10 kΩ or higher
B10-4 (SO) - Body ground Always 10 kΩ or higher
B10-6 (EO) - Body ground Always 10 kΩ or higher




OK

4.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH)
a.

Remove the No. 1 ultrasonic sensor (front corner sensor RH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL).


b.

Inspect the No. 1 ultrasonic sensor (front corner sensor RH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>INSPECTION).



OK

5.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH)

NG

REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH)

5.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH)
a.

Remove the No. 1 ultrasonic sensor (front corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL).


b.

Inspect the No. 1 ultrasonic sensor (front corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>INSPECTION).



OK

6.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH)

NG

REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH)

6.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR RH)
a.

Replace the No. 1 ultrasonic sensor (front corner sensor RH) with a normally functioning sensor (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL).



NEXT

7.CHECK FOR DTC (C1AEC)
7.CHECK FOR DTC (C1AEC)

A

8.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH)

B

END (NO. 1 ULTRASONIC SENSOR [FRONT CORNER SENSOR RH] IS DEFECTIVE)

8.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH)
a.

Replace the No. 1 ultrasonic sensor (front corner sensor LH) with a normally functioning sensor (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL).



NEXT

9.CHECK FOR DTC (C1AEC)
9.CHECK FOR DTC (C1AEC)

A

B

END (NO. 1 ULTRASONIC SENSOR [FRONT CORNER SENSOR LH] IS DEFECTIVE)