Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
86790C
1.INSTALL SIDE TELEVISION CAMERA ASSEMBLY
Install the side television camera with the 3 screws.
Connect the connector.
Install the body
Attach the 2 guides and body.
Be careful not to break the guide.
Install the body cover
Install the body with the 5 screws.
Connect the connector.
Attach the connector to the wire clip.
Install the base
Attach the guide.
Using "TORX" socket wrench T25, install the base with 3 new screws.
When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.
Install the lower mirror cover
Attach the 4 claws and install the new lower mirror cover.
Install the gasket
Attach the 9 guides and install the gasket.
Align the marking on the wire harness with the marking on the end of the wire harness insertion hole of the gasket as shown in the illustration, and wrap them with new vinyl tape starting from the gasket marking.
| *1 | New Vinyl Tape |
| *a | Marking |
| Area | Specified Condition |
|---|---|
| a | 50.0 mm (1.97 in.) |
If the vinyl tape is wrinkled, water may run down the wire harness and enter the vehicle. Make sure to wind the vinyl tape properly.
Wrap new vinyl tape as shown in the illustration.
| *1 | New Vinyl Tape |
| Area | Specified Condition |
|---|---|
| a | 30.0 mm (1.18 in.) |
| b | 50.0 mm (1.97 in.) |
81740
2.INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH
87945B
3.INSTALL OUTER MIRROR COVER LH
87961
4.INSTALL OUTER MIRROR LH
87940
5.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
86790C
6.ADJUST SIDE TELEVISION CAMERA ASSEMBLY