Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255512 PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System) J

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)  Image from Camera for Parking Assist Monitor is Abnormal  


DESCRIPTION

The display signal from the rear television camera assembly is transmitted to the multi-display assembly via the parking assist ECU.

WIRING DIAGRAM

E240589E10
5.021,1.302 5.333,1.458 0.313,0.156 10 false CB+ 5.021,0.323 5.365,0.479 0.344,0.156 10 false GVIF 1.781,0.323 2.146,0.479 0.365,0.156 10 false GVIF 4.698,1.125 4.896,1.281 0.198,0.156 10 false 14 5.021,1.698 5.344,1.854 0.323,0.156 10 false CV+ 4.708,1.521 4.906,1.677 0.198,0.156 10 false 15 5.021,2.094 5.344,2.25 0.323,0.156 10 false CV- 4.708,1.917 4.906,2.073 0.198,0.156 10 false 38 5.021,2.49 5.5,2.646 0.479,0.156 10 false CGND 1.833,1.302 2.146,1.458 0.313,0.156 10 false CB+ 1.844,1.698 2.146,1.854 0.302,0.156 10 false CV+ 1.844,2.094 2.146,2.25 0.302,0.156 10 false CV- 1.708,2.49 2.146,2.646 0.438,0.156 10 false CGND 4.708,2.313 4.906,2.469 0.198,0.156 10 false 37 2.219,1.219 2.323,1.375 0.104,0.156 10 false 4 2.219,1.615 2.323,1.771 0.104,0.156 10 false 2 2.219,2.01 2.323,2.167 0.104,0.156 10 false 1 2.219,2.406 2.323,2.563 0.104,0.156 10 false 3 5.021,2.896 5.438,3.052 0.417,0.156 10 false GND1 4.99,3.167 6.24,3.479 1.25,0.313 10 false Parking Assist ECU 0.646,2.729 0.958,2.885 0.313,0.156 10 false S5 0.646,2.875 2.833,3.042 2.188,0.167 10 false Rear Television Camera Assembly 1.125,0.677 1.51,0.833 0.385,0.156 10 false F89 1.125,0.823 2.594,0.99 1.469,0.167 10 false Multi-display Assembly 0.646,3.438 1.646,3.604 1,0.167 10 false : GVIF Cable 4.75,2.708 4.875,2.865 0.125,0.156 10 false 4 4.667,2.896 4.958,3.052 0.292,0.156 10 false F75 4.667,2.51 5.052,2.688 0.385,0.177 10 false F76 4.667,2.115 5.021,2.354 0.354,0.24 10 false F76 4.667,1.719 5.01,1.958 0.344,0.24 10 false F76 4.667,1.323 5,1.51 0.333,0.188 10 false F76 4.75,0.125 4.844,0.281 0.094,0.156 10 false 1 2.229,0.208 2.323,0.365 0.094,0.156 10 false 1 4.656,0.344 4.99,0.573 0.333,0.229 10 false F88

CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the parking assist ECU after the battery terminal has been disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/ Side Monitor System) may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Side Monitor System)>CALIBRATION).



HINT:

Images can be difficult to discern even in normal conditions. For example:

·

Noise may occur in the image during power back door operation (w/ Power Back Door System).

·

Noise may occur in the image depending on electrical devices used in the cabin.

·

Noise may occur in the image if accessories that generate radio waves have been installed.

·

The camera screen is frosted over (the image immediately after turning the engine switch on (IG) may be blurred or darker than normal).

·

The camera lens is dirty with snow, mud, etc.

·

A strong beam of light, such as a sunbeam or headlight, hits the camera.

·

It is too dark around the camera (at night etc.).

·

The ambient temperature around the camera is either too high or too low.

·

The vehicle is tilted at a steep angle.

·

The ambience of the camera is too bright. (When a strong light, such as a sunbeam reflected off the vehicle body, hits the camera, the image may be blurred. This is called the "SMEAR" phenomenon, particular to the CCD camera.)



PROCEDURE

1.CHECK SIDE MONITOR SYSTEM
a.

Check if the same malfunction occurs when the side monitor screen is displayed.

Result
Result Proceed to
Malfunction occurs when parking assist monitor screen is displayed (side monitor screen is normal). A
Malfunction occurs when parking assist monitor screen and side monitor screen are displayed. B



A

2.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY AND BODY GROUND)

B

5.CHECK HARNESS AND CONNECTOR (GVIF CABLE)
2.CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - REAR TELEVISION CAMERA ASSEMBLY AND BODY GROUND)

OK

3.CHECK PARKING ASSIST ECU (CB+, CGND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK PARKING ASSIST ECU (CB+, CGND)

OK

4.CHECK REAR TELEVISION CAMERA ASSEMBLY (CV+, CGND)

NG

4.CHECK REAR TELEVISION CAMERA ASSEMBLY (CV+, CGND)

OK

5.CHECK HARNESS AND CONNECTOR (GVIF CABLE)

NG

5.CHECK HARNESS AND CONNECTOR (GVIF CABLE)
a.

Replace the GVIF cable with a normally functioning one.


b.

Check if the same malfunction recurs when the parking assist monitor screen is displayed.

OK:

Malfunction does not reoccur (returns to normal).




OK

END (GVIF CABLE IS DEFECTIVE)

NG

6.CHECK MULTI-DISPLAY ASSEMBLY
6.CHECK MULTI-DISPLAY ASSEMBLY
a.

Replace the multi-display assembly with a normally functioning one (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>MULTI-DISPLAY (w/ Navigation System)>REMOVAL).


b.

Check if the same malfunction recurs when the parking assist monitor screen is displayed.

OK:

Malfunction does not reoccur (returns to normal).




OK

END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE)

NG