Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › MULTI-TERRAIN MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255515 MULTI-TERRAIN MONITOR SYSTEM C

PARK ASSIST / MONITORING  MULTI-TERRAIN MONITOR SYSTEM  C1611  ECU Malfunction  


DESCRIPTION

This DTC is stored if the parking assist ECU judges that there is an internal malfunction as a result of its self check.

HINT:

The parking assist ECU stores different types of information during initialization. If the parking assist ECU cannot read the stored information when it is activated, the parking assist ECU judges that there is an internal malfunction and stores this DTC.


DTC Code DTC Detection Condition Trouble Area
C1611
·

EEPROM Status (Initial read)

·

AISIC Output Status


·

Parking assist ECU initialization (not initialized parking assist ECU)

·

Back camera position setting (initialized parking assist ECU)

·

Side camera position setting (initialized parking assist ECU)

·

Steering Angle setting (initialized parking assist ECU)

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the multi-display after the battery terminal disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



PROCEDURE

1.READ VALUE USING GTS
a.

Read the Data List according to the display on the GTS (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DATA LIST / ACTIVE TEST).

Intelligent Parking Assist System / Back Guide Monitor
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Video Output Status Status of the video output status / OK or NG OK: Parking assist ECU is normal
NG: Parking assist ECU is abnormal
-
ROM/SUM Check Status of the ROM/SUM check / OK or NG OK: Parking assist ECU is normal
NG: Parking assist ECU is abnormal
-
EEPROM Status (Initial read) Status of the EEPROM check (initial read) / OK or NG OK: Parking assist ECU is normal
NG: Parking assist ECU is abnormal
-
RAM Check Status of the RAM check / OK or NG OK: Parking assist ECU is normal
NG: Parking assist ECU is abnormal
-

Result
Result Proceed to
OK is displayed for all items. A
NG is displayed except EEPROM Status (Initial read). A
NG is displayed for Video Output Status B



A

2.SETTINGS (PARKING ASSIST ECU INITIALIZATION)

B

2.SETTINGS (PARKING ASSIST ECU INITIALIZATION)
HINT:
·

The parking assist ECU stores different types of information during initialization. If the parking assist ECU cannot read the stored information when it is activated, the parking assist ECU judges that there is an internal malfunction and stores this DTC.

·

If the parking assist ECU cannot read the stored information when it is activated, allowing the ECU to store the information again may return the system to normal.



a.

Use the transition of diagnosis screens (note which transition pattern occurs) to confirm if the parking assist ECU was able to properly store the information from initialization (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>DIAGNOSIS SYSTEM).

HINT:

The procedure to make the parking assist ECU store the vehicle information differs when the parking assist ECU has stored the information (initialized) and when the information has not been stored (not initialized).



b.

Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.

Condition Procedure
Not initialized Parking assist ECU initialization (See page (Click here))
Initialized
·

Camera position setting (See page (Click here))

·

Steering angle setting (See page (Click here))





NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC


HINT:
·

If DTC C1611 is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.

·

If DTC C1611 is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.

·

If DTC C1611 is output frequently, replace the parking assist ECU even though the DTC is not output when rechecking for DTCs.




OK

END (SETTINGS ARE DEFECTIVE)

NG