Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255516 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A47  Steering Angle Sensor  


DESCRIPTION

The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication.

DTC No. DTC Detection Condition Trouble Area
C1A47 A fail flag is transmitted from the steering sensor
·

Steering sensor

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) is on.


PROCEDURE

1.CHECK FOR DTC

b.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

NG

2.REPLACE STEERING SENSOR
2.REPLACE STEERING SENSOR

NEXT

3.RECHECK DTC
3.RECHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTCs are output. A
DTC C1A47 is output ("Blind Spot Monitor Master"). B
DTC C1A47 is output ("Blind Spot Monitor Slave"). C



A

END (STEERING SENSOR WAS DEFECTIVE)

B

C