Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2015.08–2016.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255516 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AC2  Slave Module Horizontal Axis Misalignment  


DESCRIPTION

This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis.

HINT:
·

If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) on, the blind spot monitor sensor may store this DTC by mistake.

·

When mud, snow, ice, a sticker, etc. is covering the sensor or its surrounding area on the rear bumper, the blind spot monitor sensor may store this DTC by mistake.



DTC No. DTC Detection Condition Trouble Area
C1AC2 When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is activated Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) is on.


PROCEDURE

1.CHECK VEHICLE CONDITION
a.

Check the condition of the rear bumper around the blind spot monitor sensors.

HINT:

When mud, snow, ice, a sticker, etc. is covering the sensor or its surrounding area on the rear bumper, the blind spot monitor sensor may store this DTC by mistake.


Result
Result Proceed to
A sticker, mud, snow, ice, etc. is covering the sensor or surrounding area on the rear bumper. A
There are scratches or dents on the rear bumper around the sensors. B
No abnormalities.



A

2.PERFORM BEAM AXIS CONFIRMATION

B

3.CHECK INSTALLATION CONDITION
2.PERFORM BEAM AXIS CONFIRMATION
a.

Clean the rear bumper.


b.

Perform Blind Spot Monitor Beam Axis Confirmation using the GTS (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).


NOTICE:

Before replacing the blind spot monitor sensor RH, visually check for damage to the stud bolts or area surrounding the blind spot monitor sensor RH.

If there is any damage to the stud bolts or area surrounding the blind pot monitor sensor RH, perform Blind Spot Monitor Sensor Installation Condition Inspection and adjust according to the result.



OK

END

NG

3.CHECK INSTALLATION CONDITION
a.

Check the installation condition of the blind spot monitor sensor RH (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).

HINT:

Take the appropriate action in accordance with the result.




NEXT

4.PERFORM BEAM AXIS CONFIRMATION