Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255517 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  C1625  Open or Short in Steering Angle Sensor +B  


DESCRIPTION

This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem.

DTC Code Detection Item DTC Detection Condition Trouble Area
C1625 Open or Short in Steering Angle Sensor +B Open or short in steering sensor power source
·

Harness or connector

·

Steering sensor



WIRING DIAGRAM

E297310E15
3.865,2.625 5.052,2.833 1.188,0.208 10 false Steering Sensor 5.49,2.635 6.969,3.01 1.479,0.375 10 false Rear Television Camera Assembly 0.448,0.542 1.938,0.823 1.49,0.281 10 false from IG1 NO. 3 Relay 0.469,1.281 1.813,1.656 1.344,0.375 10 false from Steering Control ECU*1 0.833,1.896 1.844,2.135 1.01,0.24 10 false from Battery*2 2.26,1.406 2.573,1.698 0.313,0.292 10 false *1 2.167,2.052 3.042,2.26 0.875,0.208 10 false J/B-B NO. 1 0.729,2.927 2.469,3.188 1.74,0.26 10 false : CAN Communication Line 0.167,3.188 2.927,3.427 2.76,0.24 10 false *1: w/ Variable Gear Ratio Steering System 0.177,3.458 2.938,3.698 2.76,0.24 10 false *2: w/o Variable Gear Ratio Steering System 2.104,0.708 3.146,0.958 1.042,0.25 10 false ECU-IG1 NO. 1 3.188,0.354 3.5,0.646 0.313,0.292 10 false 4*1 3.542,0.344 3.854,0.635 0.313,0.292 10 false 4*2 3.177,1.052 3.49,1.344 0.313,0.292 10 false 5*1 3.552,1.052 3.865,1.344 0.313,0.292 10 false 5*2 3.177,2.063 3.49,2.354 0.313,0.292 10 false 1*1 3.542,2.063 3.854,2.354 0.313,0.292 10 false 1*2 3.115,0.552 3.49,0.74 0.375,0.188 10 false E163 3.479,0.552 3.844,0.74 0.365,0.188 10 false E121 3.479,1.26 3.844,1.479 0.365,0.219 10 false E121 3.479,2.271 3.844,2.51 0.365,0.24 10 false E121 3.115,1.271 3.458,1.5 0.344,0.229 10 false E163 3.115,2.271 3.458,2.5 0.344,0.229 10 false E163 3.875,0.563 4.188,0.854 0.313,0.292 10 false IG 3.875,1.281 4.188,1.573 0.313,0.292 10 false BAT 3.875,2.281 4.188,2.573 0.313,0.292 10 false ESS 3.073,1.625 3.385,1.917 0.313,0.292 10 false *2

CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the multi-display after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION).

·

Inspect the fuses for circuits related to this system before performing the following procedure.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (STEERING SENSOR - BATTERY AND BODY GROUND)
a.
U166477E03
1.896,1.125 1.729,1.719 true 1.292,2.875 1.01,3.167 true 1.333,1.125 1.052,1.417 true 2.427,1.375 2.073,1.125 true 2.531,2.344 2,2.76 true 2.583,3.063 2.208,2.885 true 0.448,0.969 0.896,1.188 0.448,0.219 10 false E163 0.104,0.094 0.323,0.313 0.219,0.219 10 false *a 0.729,1.365 1.24,1.563 0.51,0.198 10 false ESS 0.427,2.594 0.875,2.813 0.448,0.219 10 false E121 1.656,1.729 1.969,1.938 0.313,0.208 10 false IG 2.469,1.323 2.979,1.521 0.51,0.198 10 false BAT 0.667,3.104 1.177,3.302 0.51,0.198 10 false ESS 2.615,2.25 3.125,2.448 0.51,0.198 10 false IG 2.656,3 3.167,3.198 0.51,0.198 10 false BAT 0.49,0.5 1,0.698 0.51,0.198 10 false *A 0.49,2.188 1,2.385 0.51,0.198 10 false *B

Disconnect the E163*1 or E121*2 steering sensor connector.

*1: w/ Variable Gear Ratio Steering System

*2: w/o Variable Gear Ratio Steering System



b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
w/ Variable Gear Ratio Steering System:
Tester Connection Condition Specified Condition
E163-1 (ESS) - Body ground Always Below 1 Ω


Standard Resistance:
w/o Variable Gear Ratio Steering System:
Tester Connection Condition Specified Condition
E121-1 (ESS) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
w/ Variable Gear Ratio Steering System:
Tester Connection Condition Specified Condition
E163-4 (IG) - E163-1 (ESS) Engine switch on (IG) 11 to 14 V
E163-5 (BAT) - E163-1 (ESS) Always 11 to 14 V

w/o Variable Gear Ratio Steering System:
Tester Connection Condition Specified Condition
E121-4 (IG) - E121-1 (ESS) Engine switch on (IG) 11 to 14 V
E121-8 (BAT) - E121-1 (ESS) Always 11 to 14 V



Text in Illustration
*A w/ Variable Gear Ratio Steering System
*B w/o Variable Gear Ratio Steering System
*a Front view of wire harness connector
(to Steering Sensor)


OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR