Home › Power Source / Network › 3UR-FE (BATTERY / CHARGING) › CHARGING SYSTEM › from 2015.08
RM2660E _57 Power Source / Network _052834 3UR-FE BATTERY / CHARGING _0255524 CHARGING SYSTEM C

3UR-FE BATTERY / CHARGING  CHARGING SYSTEM  P161A  LIN Communication Error with Alternator  


DESCRIPTION

The ECM and generator assembly each detect reception malfunctions. A generator assembly reception malfunction detected by the generator assembly is sent to the ECM via LIN communication. If there is a malfunction in either the ECM or generator assembly, the ECM determines that there is a LIN communication malfunction and outputs a DTC.

DTC Code DTC Detection Condition Trouble Area
P161A Diagnosis condition:
Ignition switch ON
When the ECM cannot receive LIN communication, the generator assembly cannot receive LIN communication for approximately 17 minutes or more
Other: 1 trip
·

Harness or connector

·

Generator assembly

·

ECM



WIRING DIAGRAM

E221308E30
1.792,0.833 2.25,1.031 0.458,0.198 10 false 2 0.667,1.844 1.125,2.042 0.458,0.198 10 false D23 1.458,1.021 1.917,1.219 0.458,0.198 10 false LIN 0.667,1.979 2,2.229 1.333,0.25 10 false Generator Assembly 5.375,0.833 5.833,1.031 0.458,0.198 10 false 25 5.667,1.031 6.125,1.229 0.458,0.198 10 false LIN 5.833,1.833 6.292,2.031 0.458,0.198 10 false C45 5.833,2 6.292,2.198 0.458,0.198 10 false ECM 0.917,2.354 2.542,2.552 1.625,0.198 10 false : LIN Communication Line

PROCEDURE

1.CHECK CHARGING SYSTEM

OK

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
a.

Disconnect the ECM connector.


b.

Disconnect the generator assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):
Tester Connection Condition Specified Condition
C45-25 (LIN) - D23-2 (LIN) Always Below 1 Ω


Standard Resistance (Check for Short):
Tester Connection Condition Specified Condition
C45-25 (LIN) or D23-2 (LIN) - Body ground Engine switch off (while LIN communication is stopped) 10 kΩ or higher



d.

Reconnect the generator assembly connector.


e.

Reconnect the ECM connector.



OK

3.INSPECT GENERATOR ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT GENERATOR ASSEMBLY
a.


OK

NG