| Detection Item | Symptom | Trouble Area |
|---|---|---|
| Combination Meter ECU Communication Stop Mode | Either condition is met:
·
"Combination Meter" is not displayed on the "Bus Check" screen. ·
"Combination Meter ECU Communication Stop Mode" in "DTC Combination Table" applies. |
·
Power source or inside of combination meter assembly ·
Combination meter assembly |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the E7 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E7-15 (ET) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E7-17 (B) - Body ground | Always | 11 to 14 V |
| E7-18 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Combination Meter Assembly) |
| Result | Proceed to |
|---|---|
| OK (w/ Multi-information Display) | A |
| OK (w/o Multi-information Display) | B |
| NG | C |
A
(See pageVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER(w/ Multi-information Display)>REMOVAL)
B
(See pageVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER(w/o Multi-information Display)>REMOVAL)
C