| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0230 | There is no communication from the power back door unit assembly (power back door ECU). | ·
Power back door unit assembly (power back door ECU) CAN branch wire or connector ·
Power source or inside of power back door assembly (power back door ECU) ·
Power back door unit assembly (power back door ECU) ground circuit ·
Power back door unit assembly (power back door ECU) |
Before measuring the resistance of the CAN bus, turn the ignition switch off and leave the vehicle for 1 minute or more without operating the key, switches or opening or closing the doors. After that, disconnect the cable from the negative (-) battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
Reconfirm DTCs.
If DTC U1002 is output from Gateway of the main body ECU (multiplex network body ECU), this indicates a sub bus 1 malfunction. Troubleshoot for DTC U1002 and check for malfunctions in sub bus 1.
| Result | Proceed to |
|---|---|
| DTC U1002 is not output from main body ECU (multiplex network body ECU). | A |
| DTC U1002 is output from main body ECU (multiplex network body ECU). | B |
A
B
Disconnect the cable from the negative (-) battery terminal.
Disconnect the power back door unit assembly (power back door ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L52-6 (MPX1) - L52-5 (MPX2) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector
(to Power Back Door Unit Assembly [Power Back Door ECU]) |
OK
NG
Connect the cable to the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L52-11 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L52-10 (ECUB) - Body ground | Always | 11 to 14 V |
| L52-12 (B) - Body ground | Always | 11 to 14 V |
| L52-8 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Power Back Door Unit Assembly [Power Back Door ECU]) |
OK
NG