Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL RELAY (for LHD) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052838 DOOR LOCK _0255551 DOOR CONTROL RELAY(for LHD) A

DOOR LOCK  DOOR CONTROL RELAY(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 45250 3.REMOVE STEERING COLUMN ASSEMBLY (for Manual Tilt and Manual Telescopic Steering Column)

Hide 45250 4.REMOVE STEERING COLUMN ASSEMBLY (for Power Tilt and Power Telescopic Steering Column)

Hide 85970A 5.REMOVE DOUBLE LOCK DOOR CONTROL RELAY ASSEMBLY

a.
B300740

Disconnect the connector.


b.

Remove the bolt and double lock door control relay assembly.