1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45287
3.REMOVE LOWER STEERING COLUMN COVER
45286B
4.REMOVE UPPER STEERING COLUMN COVER
89783
5.REMOVE TRANSPONDER KEY AMPLIFIER
69057A
6.REMOVE IGNITION SWITCH LOCK CYLINDER ASSEMBLY
84052
7.REMOVE UNLOCK WARNING SWITCH ASSEMBLY
Disconnect the unlock warning switch connector.
Detach the 2 claws and slide the unlock warning switch as shown in the illustration.
Push in the pin, slide the unlock warning switch as shown in the illustration and remove it.
| *1 | Pin |