Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
74280
2.REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH
69278C
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH
74611C
4.REMOVE ASSIST GRIP COVER LH
81230
5.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER LH
69340
8.REMOVE REAR DOOR LOCK ASSEMBLY LH
69227L
9.REMOVE REAR DOOR OUTSIDE HANDLE COVER LH
69240
10.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
Using a T30 "TORX" wrench, loosen the screw.
Disconnect the connector.
Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.