When the intrusion sensor cancel switch on the map light assembly is pressed, the sensor off signal is sent to the main body ECU (multiplex network body ECU) which causes the intrusion sensor to stop operating.
If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.
w/ Door Control Battery:
As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure.Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Intrusion Sens OFF SW | Intrusion sensor cancel switch/ON or OFF | ON: Intrusion sensor cancel switch on
OFF: Intrusion sensor cancel switch off |
- |
The indicator on the GTS switches between ON and OFF in accordance with the intrusion sensor cancel switch status.
OK
NG
Disconnect the E117 main body ECU (multiplex network body ECU) connector.
Disconnect the R7 map light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E117-13 (SSW1) - R7-11 (SOFF) | Always | Below 1 Ω |
| R7-17 (GND9) - Boy ground | Always | Below 1 Ω |
| E117-13 (SSW1) - Body ground | Always | 10 kΩ or higher |
| R7-11 (SOFF) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the map light assembly (intrusion sensor cancel switch) (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>INTRUSION SENSOR>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 11 (SOFF) - 17 (GND9) | Intrusion sensor cancel switch not pressed | 10 kΩ or higher |
| 11 (SOFF) - 17 (GND9) | Intrusion sensor cancel switch pressed | Below 1 Ω |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
A
B
C